Laser Engraving Cutting Software User Manual----RDCAM V8.0
4.10.3 Laser scanning parameters settings
On the left of the dialog box is vector scanning parameters settings, on the right side of the dialog
box is bitmap scanning parameters settings.
The vector data does not support the negative engrave, optimized scan, output direct.
Negative engrave: In normally scanning, laser emitted from black spots in the bitmap, no laser in
white spots. Choose the negative engrave, laser emitted from white spots in the bitmap, no laser in
the black spots.
Optimized scan: choose “optimized scan” will automatically adjust the users setting “scanning
interval” to the best value, the scan effect would be the best. Otherwise, according to “scanning
interval” to scan, generally choose “optimized scan”.
Direct output: For gray scale bitmap, output as the actual graphics gray.
Primitive output respectively: for vector graphics, primitive output respectively outputs the
gathered closely vector primitive engraving respectively, according to the vector primitive position
relations.
If not checked “Primitive output respectively”, it will engrave the whole vector graphics as
one vector graph.
For a bitmap, if not checked “Primitive output respectively”, the system will automatically
output a bitmap in the same layer as a whole output.
If checked “Primitive output respectively”, the system will be in a single output bitmap.
Ramp effect: making the scan graphic edge appeared slope and stereo effect.
Font Bold: including not processing, scanning the font, scanning the bottom. Generally choose
70 / 76
© 2016 Ruida Technology. All Rights Reserved.
